The Connect software and the Connect Case Center simplify the cooperation between dental practice and laboratory. Once registered, both sides communicate directly through the Connect Case Center. The data model is transferred within a few minutes and gives the laboratory an exact picture of the case.
The direct transmission of model data to your lab within a few minutes allows your dental technician to look at the case almost simultaneously with the practice. Thus, a first consultation with your laboratory can already be done while the patient is still in the treatment room. Another advantage over conventional impression methods.
Prepare, scan, send - the digital impression is so simple. It can be easily integrated into your existing treatment process. The complete design of the restoration is carried out as usual by the laboratory of your choice.
The workload in your practice is considerably simplified. With just a few scans, you can capture your preparation, neighboring teeth and antagonists. A half-jaw can be recorded in less than a minute. You can maintain a convenient treatment position the entire time. The 3D preview of the individual recordings also makes your work easier.
Patients do not experience the urge to gag
Simply take the impression and send
Enter a new era of digital patient care
Our new wireless intraoral scanner is simple and versatile, easily integrating into your practice's existing setup to help you grow your practice and deliver exceptional patient care.
Practice users are guided through the four phases of digital impressions step-by-step:
The digital impression is visualized on the monitor as a 3D model. Different surfaces are shown in their natural color – for improved orientation in the oral cavity and clear distinction between the preparation margin and gingiva.
Digital impressioning with Primescan and Omnicam supports a large range of indications from single tooth and bridge restorations to implant planning and design, as well as orthodontic applications.
Prepare, scan, send – the digital impression is so simple. With Connect, your practice benefits from an innovative process for processing precise digital impressions. Registration is free of charge for Primescan and Omnicam users.
| Dimensions (H x B x T) | 121 x 36 x 47 cm |
| Monitor | 19“, 1.280 x 1.024 pixel monitor resolution |
| Device weight | 43 kg |
| Camera weight | 313 g |
| Camera length | 20 cm |
| Powder-free | Yes |
| Color | Yes |
| Acquisition technique | Filming: The data is recorded continuously without blurring by means of the flowing acquisition technique. The camera is moved over the tooth surgace at a distance of 0 to 15 mm. |
| Power supply | - Standard power supply (100–230 V, 50/60 Hz) - Optional: Uninterruptible power supply (short-term battery) |
| Network connection | LAN und WLAN |
| Software | Sirona Connect SW (no follow-up costs) - Acquisition of preparation, antagonist and bite registration - Computation of the 3D model - Drawing the preparation margin - Link to Sirona Connect Portal |
| Indications | Crowns and bridges, inlays, onlays, veneers, temporary restorations, abutments and surgical guides (restricted), orthodontics (CEREC Ortho), model casting |
| CEREC Omnicam Versions | - CEREC AC with Omnicam - CEREC AF with Omnicam - CEREC AI with Omnicam All three CEREC Omnicam versions can be installed in the practice as a special Connect version and thus used solely as an impression unit, i.e., only for taking and sending impressions and not for design. |
* inLab SW interface module for .STL export required
